Installation Guide

Contact us for assistance: [phone] | www.wtliving.com
5
ASSEMBLY
1
Attach Wheel Assembly
F
to Tank Assembly
E
. Line up
holes in Wheel Assembly with corresponding holes in base
and insert 2pcs M8x16 Bolt
G
through holes. Finger tighten
bolts. Be sure that the Wheel Assembly is parallel to base and
fully tighten the bolts.
Hardware Used: 2x M8x16 Bolt
2
Attach the Cylinder Bracket
L
to base of the
Tank
Assembly
E
with the 3 - M8x12 Bolts
M
and 3 - M8
Nuts
N
that are pre-assembled in the Cylinder Bracket
L
. Use
the M8x45 Bolt
O
(pre-assembled in the Cylinder Bracket) to
secure the LP gas cylinder in place once it has been placed on
the base inside the Tank Assembly
E
.
Hardware Used: 3x M8x12 Bolt
3x M8 Nut
3x M8x45 Bolt
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents
list and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to
assemble this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBLY TIME:
60 minutes
Tools Required for Assembly (NOT included):
• 7/16” open-end wrench
• Adjustable opening wrench
• Philips screwdriver with medium blade
• Leak Test Solution (see instructions on page 9 on how to make solution.)
Note: This heater has an Electronic Ignition and will require installation of 1 – AA battery. Install t
he
battery by unscrewing the RED IGNITER BUTTON. Battery not included.
2
G
F
E
N
M
O
L
M
M
O
O
N