Installation Guide

ManualsBrandsFire Sense ManualsOutdoor Heating40,000 BTU Hammered Bronze Spiral Gas Patio Heater

SPIRAL FLAME PATIO HEATER

ASSEMBLY / CARE & USE INSTRUCTIONS

IMPORTANT, RETAIN FOR FUTURE

REFERENCE: READ CAREFULLY

Questions, problems, missing parts?

Before returning to your retailer, our exceptional customer service is available. Call us

toll-free at (866) 985-7877 Monday – Friday, 9 a.m. – 6 p.m., EST, email us at

cservice@welltraveled.net, or

go online and live chat at www.wtliving.com.

English and Spanish speaking.

DANGER

FOR YOUR SAFETY:

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open ame.

3. If odor continues, keep away from the

appliance and immediately call your gas

supplier or re department.

DANGER

Failure to comply with the precautions

and instructions provided with this heater

can result in death, serious bodily injury

and property loss or damage from hazards

of re, explosion, burn, asphyxiation,

and/or carbon monoxide poisoning. Only

persons who can understand and follow

the instructions should use or service

this heater.

WARNING

Do not store or use gasoline or other

ammable vapors and liquids in the

vicinity of this or any other appliance.

An LP-cylinder not connected for use

shall not be stored in the vicinity of this

or any other appliance.

WARNING

Improper installation, adjustment,

alteration, service or maintenance can

cause property damage, injury or death.

Read the installation, operation and

maintenance instructions thoroughly

before installing or servicing this

equipment.

WARNING

THIS ITEM IS INTENDED FOR OUTDOOR

DOMESTIC USE ONLY, NOT FOR

COMMERCIAL USE.

ATTACH YOUR

RECEIPT HERE

Keep a copy of your proof of

purchase or order conrmation

which will be needed if you

need to contact us about

warranty coverage.

Serial No.

Purchase Date

WARNING

This product can expose yo

u to chemicals including

Carbon Monoxide, Lead, Chromium (hexavalent

compounds), Di(2-ethylhexyl) phthalate (DEHP) and

Diisononyl phthalate (DINP), which are known to

the State of California to cause cancer and birth

defects or other reproductive harm. For more

information, go to www.P65Warnings.ca.gov.

Item #: 63057

Manual updated Nov 2018

Summary of content (14 pages)

PAGE 1
Item #: 63057 SPIRAL FLAME PATIO HEATER ASSEMBLY / CARE & USE INSTRUCTIONS IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY DANGER FOR YOUR SAFETY: If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call your gas supplier or fire department. WARNING Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
PAGE 2
BEFORE YOU BEGIN Table of Contents Before You Begin Page 2 Safety Information Page 3 Package Contents Page 4 Hardware Contents Page 4 Assembly Page 5-7 Operating Instructions Page 8-11 Care and Maintenance Page 12 Troubleshooting Page 13 Warranty Information Page 14 BEFORE YOU BEGIN Please read and understand this entire manual before attempting to assemble, operate or install this appliance.
PAGE 3
SAFETY INFORMATION DANGER EXPLOSION—FIRE HAZARD • Keep solid combustibles, such as building materials, paper, or cardboard a safe distance away from the heater as recommended by the instructions. • Provide adequate clearances around air openings into the combustion chamber. • Never use the heater in spaces which do or may contain volatile or airborne combustibles, or products such as gasoline, solvents, paint thinner, dust particles, or unknown chemicals.
PAGE 4
PACKAGE CONTENTS A B C S D PART DESCRIPTION QUANTITY A Reflector 1 B Emitter Screen 1 C Protection Guard 4 D Glass Tube 1 E Tank Assembly 1 F Wheel Assembly 1 S Rubber Ring 1 Battery (AA) not included Note: This heater has an Electronic Ignition and will require installation of 1 AA battery. The battery should be installed by unscrewing the RED IGNITER BUTTON - battery not included.
PAGE 5
Assembly PREPARATION Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble this product. Contact customer service for replacement parts.
PAGE 6
Assembly 3 Attach Anchoring Arm P to the base of the Tank Assembly E with 2 pieces of M6x12 Bolt R and M6 Nut H. Note: If you are using the Wheel Assembly F, you will only be able to attach 2 Anchoring Arms to the base. Once you have completed assembly of the heater, you can use the E Anchoring Arm/Pin to secure the heater to the ground by inserting an Anchoring Pin Q through the hole in the Anchoring Arm P and into the ground.
PAGE 7
ASSEMBLY 6 Place the Rubber Ring S on the bottom rim of the Glass Tube S. Carefully lower the Glass Tube onto the Tank Assembly E. 7 B D D Place the Emitter Screen B onto the Protection Guards C. Make sure the threads go through holes on bottom of Emitter Screen assembly. S E 6 8 6 7 Use 8 - M6 Nuts H to tighten Protection Guards C. H B Hardware Used: 3x M6 Bolt C 8 9 Assembly is now complete. 9 Contact us for assistance: (866) 985-7877 | www.wtliving.
PAGE 8
Operating Instructions Hose / Regulator Regulator / Cylinder Connection Connection A minimum supply pressure of .5 psi is required for the purpose of input adjustment of propane gas. Storage of an appliance indoors is permissible • cylinder under or near this only if the cylinder is disconnected and removed from the appliance. A cylinder must be stored outdoors in a well-ventilated area out of the reach of children.
PAGE 9
Operating Instructions Before Turning Gas Supply ON: LEAK TEST WARNING 1. Make 2-3 oz. of leak test solution (one part liquid dish washing detergent and three parts water). 2. Apply several drops of solution where hose attaches to regulator. • Perform all leak tests outdoors. • Extinguish all open flames. • NEVER leak test when smoking • Do not use heater until all connections have been leak tested and show no signs of leakage. 1. Your heater was designed and approved for OUTDOOR use only.
PAGE 10
Operating Instructions Lighting WARNING NOTE: If burner fails to remain lit, all valves should be close and a waiting period of at least 5 minutes should pass before attempting to light. 1. Turn the control knob to the OFF position. 2. Fully open the LP cylinder valve. 3. Push in and turn the control knob counter clockwise to PILOT. 4. While holding control knob in, push the RED igniter button to ignite the main burner.
PAGE 11
Operating Instructions OPERATION CHECKlIST: For a safe and pleasant heating experience, perform this check before each use: WARNING FOR YOUR SAFETY Heater will be hot after use. Handle with extreme care. Before Operating: m I am familiar with entire owner’s manual and understand all precautions noted. m All components are properly assembled, intact and operable. m No alterations have been made. m All gas connections are secure and do not leak. m Wind velocity is below 10 mph.
PAGE 12
Care and Maintenance To enjoy years of outstanding performance from your heater, make sure you WARNING perform the following maintenance activities on a regular basis: Keep exterior surfaces clean. 1. Use soapy water for cleaning. Never use flammable or corrosive FOR YOUR SAFETY • Do NOT touch or move heater for at least 45 minutes after use. • Reflector is hot to the touch. • Allow reflector to cool before touching. cleaning agents. 2.
PAGE 13
Troubleshooting PROBLEM Main burner will not light Low burner flame Burner unit POSSIBLE CAUSE CORRECTIVE ACTION Gas valve may be off Turn gas valve ON Fuel tank may be empty Refill LPG tank Orifice blocked Clean or replace orifice Air in supply system Purge air from lines. Open gas lines and depress control knob for 2-3 minutes.
PAGE 14
1 YEAR lIMITED WARRANTY Customers in the Contiguous US All components are warranted for a period of 1 year after date of purchase by the original owner against defects in materials and workmanship under normal use. This warranty does NOT cover normal wear and weathering, assembly and/or maintenance OR use in a commercial application if model is not designated as a commercial model.