Instructions / Assembly

Contact us for assistance: [phone] | www.wtliving.com 7
ASSEMBLY
5
6
Carefully pour the Fire Glass L around the Burner. Do not
obstruct the pilot light housing. Put the Removable Burner
Cover A on the Burner.
When the fire pit is not in use, or after use, when the fire
pit has cooled COMPLETELY, cover it with the Protective
Cover K. DO NOT PUT THE PROTECTIVE FIRE PIT
COVER ON A HOT FIRE PIT.
5
6
M
M
L
K
A
On a nonabrasive, protected surface, turn the Table Top B
upside-down. Using the Screwdriver P, screw each of the 4
Studs M into the holes near the corners of the burner opening
as shown.
Turn the Table Top upright and carefully lower it onto the
assembled fire pit base, inserting the Studs through the
drilled holes at the corners of the Burner Bracket and then
through the holes at the upper corners of the base.
Fasten the Table Top to the base by placing a Washer/Spring
Washer/Nut M onto each Stud as shown in the inset. Tighten
using Wrench Q.
M Stud (8x60mm) x 4
M Washer (8mm) x 4
M Spring Washer (8mm) x 4
M Nut (8mm) x 4
Hardware Used:
WARNING:
This fire pit is constructed of aluminum, a
relatively soft, flexible metal. Do not sit,
stand, or lean heavily on the top of the fire
pit, which can cause bending or warping.