Installation Guide

Contact us for assistance: [phone] | www.wtliving.com 11
OPERATING INSTRUCTIONS
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually
ignite this heater. Holding in the control
knob for more than 10 seconds before
igniting the gas will cause a ball of ame
upon ignition.
LIGHTING
NOTE: For initial start or after any cylinder
change, hold the control knob in for 2
minutes to purge air from all gas lines
before proceeding.
1. Turn the control knob to the “OFF”
position.
2. Fully open the LPG tank valve.
3. Push in and turn the control knob
to HI symbols.
4. Keep the control knob depressed
and then push the RED igniter button
simultaneously, push several times to
ignite the main burner. Repeat until the
burner ignites. Keep the control knob
fully depressed for an additional 30
seconds after the burner ignites, then
release the control knob.
5. To increase the ame, turn the control
knob clockwise towards HI. To
decrease the ame, turn the control
knob counter-clockwise towards LO.
6. To turn the appliance OFF, depress the
control knob and turn clockwise to the
OFF position.
7. Wait at least 5 minutes before
attempting to re-light the heater.
8. Turn the LPG tank valve to OFF
or closed. If you experience any
ignition problems, please consult
“Troubleshooting” on page 16.
WHEN HEATER IS ON:
Emitter screen will become bright
red due to intense heat. The color
is more visible at night. Burner will
display tongues of blue and yellow
ames. These ames should not
be yellow or produce thick black
smoke, indicating an obstruction
of airow through the burners. The
ame should be blue with straight
yellow tops. If excessive yellow
ame is detected, turn off heater
and consult “Troubleshooting” on
page 14.
RE-LIGHTING:
Note: For your safety, the control
knob cannot be turned OFF
without rst depressing the
control knob and then rotating
to OFF.
1. Turn control knob to OFF.
2. Wait at least 5 minutes to
allow gas to dissipate before
re-lighting.
3. Repeat the “Lighting” steps
listed above.
PUSH &
HOLD
PUSH IN
TURN
PUSHING
IN BUTTON
WHILE
Caution: Avoid inhaling fumes emitted from the heater’s rst use. Both
smoke and odor from the burning of oils used in the manufacturing will
appear. Both smoke and odor will dissipate after approximately 30 minutes.
The heater should NOT produce thick black smoke.
If you experience any ignition problems, please consult “Troubleshooting”
on page 14. Caution: Avoid inhaling fumes emitted from the heater’s rst
use. Smoke and odor from the burning of oils used in the manufacturing
will appear. Both smoke and odor will dissipate after approximately
30 minutes. The heater should NOT produce thick black smoke.