Full Product Manual

5
4
5
E
G
I
Attach the Back Panel
F
to both Side Panels
by
aligning the eyelets on the back of the Back Panel with
the eyelets near the rear of the arms of the Side
Panels. Insert a Bolt G with Washer I into each of the
aligned sets of eyelets.
Attach the Back Panel to the Seat Panel by aligning the
holes at the bottom of the Back Panel with the eyelets
near the rear of the Seat Panel. From the underside of
the Seat Panel, insert a Bolt H with Washer I into
each of the aligned eyelets/holes.
Tighten all Bolts using the Hex Key but do not over-
tighten.
Check all hardware. Adjust and tighten where
necessary for a secure connection, but do not
over-tighten.
Hardware Used: G Bolt (M6x20) x2
H Bolt (M6x30) x2
I Washer x4
Your Bondi Chair is fully assembled!
Contact us for assistance: [phone] | www.balkenehome.com
H
I
B
ASSEMBLY