Full Product Manual

Locate the Right Side Panel

and lay it on a flat surface with

the open side facing up and the feet towards you. Place a

Washer I on each of 5 Bolts G. Position the Seat Panel B on

the Right Side Panel as shown. Align the eyelets on each

panel and insert a Bolt with Washer through each of the 2

aligned eyelets and gently tighten. Position the Front Base

Panel C as shown and secure to the Side Panel and Seat

Panel using 3 Bolts with Washers.

Tighten using the Hex Key but do not over-tighten.

Hardware Used:

G Bolt (M6x20) x5

I Washer x5

Attach the Rear Back Panel

to the Right Side Panel

and

the Seat Panel B: align the eyelets on the Rear Back Panel

with the eyelets on the already joined panels as shown, then

insert a Bolt G with Washer I into each of the 3 aligned sets

of eyelets.

Tighten using the Hex Key but do not over-tighten.

Hardware Used:

Locate the Left Side Panel E and lay it on a flat surface with

the open side facing up and the feet towards you. Position

the partially-assembled chair on top of the Left Side Panel

as shown. Place a Washer I on each of 6 Bolts G. Align the

eyelets on each panel and insert the 6 Bolts with Washers

through the aligned eyelets as shown.

Tighten using the Hex Key but do not over-tighten.

Hardware Used:

G Bolt (M6x20) x3

I Washer x3

G Bolt (M6x20) x6

I Washer x6

ASSEMBLY