Installation Guide

ASSEMBLY

Connect hose and regulator to cylinder. The propane gas

and cylinder are sold separately. Use a standard 20lb

propane cylinder only. Use this re pit only with a propane vapor

withdrawal supply system. See chapter 5 of the standard storage

and handling of liqueed petroleum gas, ANS/NFPA 58. Your local

library or re department should have this book.

Storage of an appliance indoors is permissible only if the cylinder

is disconnected and removed from the appliance. A cylinder must

be stored outdoors in a well-ventilated area out of the reach of

children. A disconnected cylinder must have dust caps tightly

installed and must not be stored in a building, garage or any other

enclosed area. The maximum inlet gas supply pressure: 250 psi,

the minimum inlet gas supply pressure: 5 psi.

The minimum hourly of 10,000 BTU is required input rating for a

re pit for automatic operation at ratings less than full input rating.

The pressure regulator and hose assembly supplied with the

appliance must be used.

The installation must conform with local codes, or in the absence

of local codes, with national fuel gas code, ANS Z223.1/NFPA54,

natural gas and propane Installation Code, CSA B 149.1, or propane

storage and handling code, B149.2.