Installation Guide

Contact us for assistance: [phone] | www.wtliving.com 6
ASSEMBLY
3
Lay the Table Top
C
upside down on an even soft clean
surface. Screw 4 - Studs 8x30mm
K
into the Table Top
using the Screwdriver
R
.Then turn the Table Top over, and align
the Studs with the holes in the top of legs. Slide Washer/Spring
Washer/Nut 8mm
L
over the end of the Stud and secure with Nut
8mm. Tighten with Wrench
S
. Place the Burner
B
into the hole in
the Table Top. Make sure the control knob on the Burner is aligned
with the Door Panel.
Hardware Used: 4 - Stud 8x30mm
4 - Washer, Spring Washer, Nut 8mm
4
Carefully pour the Fire Glass
J
around the Burner. Be careful
not to obstruct pilot light housing. Place the Burner Cover
A
on the Burner when the re pit is NOT in use. When the re pit
is completely cool, you may cover it with the Protective
Cover
I
. DO NOT PUT THE PROTECTIVE FIRE PIT COVER
ON A HOT FIRE PIT.
3
4