Instructions / Assembly

Reflector (#2) is comprised of 3 – outer pieces and 1 – center piece. Locate all 4
pieces of Reflector (#2) which are wrapped in bubble wrap. Unwrap and remove
all pieces and peel off the protective blue plastic on each piece. Locate 9 bolts and
9 cap nuts in the plastic bag. Align the 3 – outer pieces with the 1 – center piece
and place a bolt through the center hole on each piece as shown below. Tighten
castle nut on each bolt.
ASSEMBLY
Next, align the sides of each outer piece and the center piece and insert the
next 3 bolts through both holes. Tighten castle nuts on bolts.
Finally, insert bolt through holes located at outside edge of adjoining panels
of the reflector side pieces (3 bolts required) and tighten castle nuts on bolts.
- 9 -