Outdoor Patio Heater Model # LIP-10A-TGG Item # 60951 ATTACH YOUR RECEIPT HERE Serial Number ___________ Purchase Date ______ Manufacturer: Changzhou Wellife Furnace Co., Ltd. Questions, problems, missing parts? Before returning to your retailer, call our customer service hotline at 1-866-985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday or email at cservice@welltraveled.net.
PACKAGE CONTENTS ASSEMBLY PART A B - 2- DESCRIPTION Reflector Panel and Center Cap Head and Upper Post Assembly QTY 5 pcs (packed in 2 inner ctns) 1 C Gas Hose 1 (attached to Head Assembly) D Regulator 1 E Lower Post 1 F Post Support Plate 1 (packed under Tank Housing Assembly) G Tank Housing Assembly 1 H Tank Housing Support Bar 1 (contains 2 – M4x10 countersunk screws) I Tank Housing Door 1
HARDWARE CONTENTS ASSEMBLY SAFETY INFORMATION SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install this appliance. If you have any questions regarding the product, please call customer service 1-866-985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday. This manual contains important information about the assembly, operation and maintenance of this patio heater.
SAFETY INFORMATION - 4-
SAFETY INFORMATION ASSEMBLY PREPARATION Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list and hardware contents as listed on pages 2 and 3 of this manual. If any part is missing or damaged, do not attempt to assemble this product. Contact customer service for replacement parts.
ASSEMBLY 1. Locate Tank Housing Assembly (G) and Tank Housing Support Bar (H). Attach Tank Housing Support Bar (H) to the top front edge of the Tank Housing Assembly (G) with 2 M4x10 (HH) Countersunk Head Screws (screws come pre-assembled in the Tank Housing Support Bar.) 1 Hardware Used: 2 x HH, Countersunk Head Screw M4x10 2 2. Attach the Lower Post (E) to the Post Support Plate (F) using 4 M8x16 (AA) Bolts and 4 M8 (GG) Washers. (Note: Turn the post and support plate upside down to secure the bolts.
ASSEMBLY 3. Attach the Post Support Plate (F)/Lower Post (E) to the Tank Housing Assembly (G/H). (NOTE: Make sure Firesense® logo is facing forward directly over the Tank Housing Support Bar.) Align the holes in the Post Support Plate (F) With the holes in the top of the Tank Housing Assembly (G/H) and insert a total of 12 M4x10 (CC) bolts into the holes and loosely tighten. Once all bolts have been inserted, tighten with a wrench. Hardware Used: 12 x CC, Bolt M4x10 4.
ASSEMBLY 5 5. Carefully route the Gas Hose (C) that comes attached to Head and Upper Post Assembly (B) completely through the Lower Post/Post Support Plate Assembly (E/F). (Hint: Control knob on Head Assembly should be located over the Tank Housing Door.) 6. Attach Head Assembly and Upper Post Assembly (B) to the Lower Post (E) by aligning the 4 small holes located on the Upper Post with the 4 small holes located on the Lower Post (E).
ASSEMBLY 8. While supporting heater, tilt the Head and Upper Post Assembly (B) and screw in the 3 M8x70 Stud Bolts (BB) into the holes on top of the Head Assembly. Slide the assembled Reflector over the 3 bolts that now extend from the Head Assembly. Use the 3 M8 Wing Nuts (EE) and 3 M8 Washers (GG) to secure the assembled Reflector to the Head Assembly of the heater. Once you have tightened the Wing Nuts, return the heater to an upright position. 8 Hardware Used: 3 x EE, Wing Nut M8 3 x GG, Washer M8 9.
ASSEMBLY 10. Connect the hose and regulator to the LP cylinder. The LP cylinder is sold separately. Use a standard 20 lb. propane cylinder only. Screw Regulator (D) onto Gas Hose (C). Do not cross thread. Hand tighten securely. Attach Regulator (D) to valve on LP cylinder and hand tighten securely. Place LP tank onto base of heater and close Tank Housing Door (I). NOTE: Use this heater only with a propane vapor withdrawal supply system.
OPERATING INSTRUCTIONS A minimum supply pressure of .5 psi is required for the purpose of input adjustment of propane gas. Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance. A cylinder must be stored outdoors in a well-ventilated area out of the reach of children. A disconnected cylinder must have dust caps tightly installed and must not be stored in a building, garage, or any other enclosed area.
OPERATING INSTRUCTIONS 3. If leak is detected at regulator/cylinder valve connection, disconnect, reconnect, and perform another leak check. If you continue to see bubbles after several attempts, cylinder valve is defective. Call our customer service hotline at 1-866-985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday IF NO BUBBLES APPEAR AT ANY CONNECTION, THE CONNECTIONS ARE SECURE. Note: Whenever gas connections are loosened or removed, you must perform a complete leak check.
OPERATING INSTRUCTIONS When Heater is ON: Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner will display tongues of blue and yellow flame. These flames should not be yellow or produce thick black smoke, indicating an obstruction of airflow through the burners. The flame should be blue with straight yellow tops. If excessive yellow flame is detected, turn off heater and consult “Troubleshooting” on page 15.
OPERATING INSTRUCTIONS After Operation: 1. Gas Control Knob is in OFF position. 2. Gas tank valve is OFF. 3. Disconnect gas line. CARE AND MAINTENANCE To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance activities on a regular basis: Keep exterior surfaces clean. 1. Use soapy water for cleaning. Never use flammable or corrosive cleaning agents. 2.
TROUBLESHOOTING If you have any questions regarding this product, please call our customer service hotline at 1-866-985-7877, 9a.m. – 6 p.m. (EST), Monday – Friday, or email us at cservice@welltraveled.net. PROBLEM POSSIBLE CAUSE Gas valve may be off Main burner will not light Refill LPG tank Orifice blocked Clean or replace orifice Air in supply system Purge air from lines. Open gas lines and depress control knob for 2-3 mins.
Distributed By: Well Traveled Living 716 S 8th Street Amelia Island, FL 32034 Toll Free: 866-WTL-SUPP (866-985-7877) Web: www.wtliving.com Email: cservice@welltraveled.net 1 YEAR LIMITED WARRANTY – Customers in the Continental US All components are warranted for a period of 1 year after date of purchase by the original owner against defects in materials and workmanship under normal use.
