Instructions / Assembly

Cross head bolt (6 pcs)
Nut (9 pcs)
Small bolts (8 pcs)
h
m
l
Fig.1
h
AD
CB
h
Fig.2
Fig.5
Fig.4
Fig.3
F
Before You Begin
Parts List
*1 piece Stainless Steel Firebowl
*4
pieces Steel Fire Screen (A,B,C,D)
*1 piece Fire Screen Handle (with pre-assembled nut)
*1 set Decorative Stand Assembly:
Includes: 3 legs, 1 large ring, 1 small ring
*1 piece
FireScreen Lift Tool
*1 piece Steel Log Grate
Tools Required:
*Hardware:
Screw driver(not included).
Check to make sure you have the following:
Remove all parts from packing and check to make sure you have all parts described in “Before You Begin” section above.
Spread out parts on a soft, level surface to avoid scratching parts.
Step 1 :
* Attach 3 legs of the decorative stand to the large ring. Align threaded holes on the large ring with
pre-drilled holes in the tops of the legs. Secure with cross head bolts
(h) and hand tighten. See Fig.1.
* Attach small ring to middle brackets locate on decorative legs. Position small ring into the channels. Align holes
and insert cross head bolts (h) and hand tighten. See Fig. 1.
*
Make sure all stand components are square to one another and the entire assembly is level with the floor.
Then tighten all cross head bolts securely with screwdriver.
Step 2:
*Identify the 4 fire screen components and lay them out on the floor.
Make sure you have A,B,C,D (four pieces of
screen
.) The letters are marked on each piece of screen.
*Stack four screens and make sure screen A and B are above C and D. See Fig. 2. Loosen nut on the handle and
insert handle through screen top hole. Tighten nut onto handle from inside of the screen. Do not over tighten.
*
Connect bottom holes on each screen together using small bolts (l) and nuts (m). See Fig. 3. The
bolts must always be fastened towards the inside of the screen assembly. You need one bolt
(l) and nut (m)
to fasten two screen lids together. See Fig.4.
*Connect middle holes on four screens using the same method.
Step 3:
*Place bowl onto leg assembly. Note: Ridge line on firebowl should be resting on upper rim or leg assembly.
Make sure bowl is level and square with leg assembly.
*Place steel log grate onto bottom ridge of bowl so that it lays flat. Place assembled fire screen onto the fire
bowl centering it and making sure it is level. See Fig. 5.
CAUTION:
NEVER use your hands to open or close the screen when hot. Use the lift tool provided.
Preparation
Assembly Instructions
Fire Screen
Assembled Firepit
2