Instruction Manual

16
IDENTIFICATION OF GRILL CONTROLS
Power burner control locations
Double sideburner control locations
Inner power burner
control knob
Outer power burner
control knob
Fig. 16-2
Left
main burner
control knob
Right
main burner
control knob
Right backburner
control knob
Digital
thermometer
Sideburner
control knob
Center
main burner
control knob
Fig. 16-4
Left
main burner
control knob
Right
main burner
control knob
Backburner
control knob
Digital
thermometer
Sideburner
control knob
E1060s control locations
E660s and E790s control locations
Smoker
drawer burner
control knob
Center right main
burner
control knob
Center left main
burner
control knob
Drip
tray
Drip
trays
Smoker drawer
burner control
knob
Left backburner
control knob
Power hood
control
(if equipped)
Fig. 16-1
To remove the control panel:
• Turn off the gas shutoff valve.
• Pull off the control knobs. Slowly lift away the lighted bezels to clear the valve stems, and carefully disconnect the wires found
on the back of the bezels (use your fi ngernail.) Remove the woodchip box. Unscrew and remove the control panel screws and
washers.
• Lift the control panel up and outward, allowing it to rest on the internal chain(s).
Important: When re-installing the control panel, set it back over the front lip of the grill so that the lid-closed-sensor
plunger protrudes through the hole on the upper right of the control panel. Prior to opening the gas shutoff
Control panel
screw(s)
Control panel
screw(s)
Woodchip
box
Woodchip
box
Fig. 16-5
Bezel
installed
Bezel
removed
Carefully
disconnect
Power hood
control
(if equipped)
Master
switch
Master
switch
Rear sideburner
control knob
Front sideburner
control knob
Fig. 16-3