Installation Manual

31
BURNER REMOVAL
1. Remove the control panel, cooking grids, and
flavor grids and set them aside. See the CONTROL
PANEL REMOVAL and COOKING GRID REMOVAL
sections for details.
2. Locate the burner clip (located over the rear center
tube of the burner) and slightly pinch and remove
the clip from the burner support. See Fig. 31-1.
3. Carefully lift the burner from the burner support anchor
peg holes and out from the hole in the forward fire
wall.
4. To replace the burner, slide the open cylindrical end
of the burner around the orifice, enveloping it and
centering on it. Then lower the back end anchor pegs
into the burner support anchor peg holes.
Note: It is critical to the continued safe functioning of the
burners that the orifices are centered and
completely inside the burner gas inlets.
5. Re-install the burner clip around the burner and into
the holes in the burner support.
6. Replace the flavor grids, cooking grids, and control
panel.
Fig. 31-1 Main burner removal
Remove
burner clip
WARMING RACK REMOVAL
Note: Wear heat-resistant gloves if necessary.
1. Locate the warming rack locking brackets found
on the rear left and right side of the warming rack
(see Fig. 31-2).
2. Use a short-handled Phillips screwdriver to remove
the screw from a locking bracket. Then remove the
bracket. See Fig. 31-3.
3. Repeat for the other bracket.
4. Carefully remove the warming rack by lifting the
front end up from the hooks, then outward.
Important: When reinstalling, place cardboard (or
similar) on the cooking grid surface to
prevent the screws from falling down into
the unit.
Fig. 31-2 Warming rack locking brackets
Locate warming rack
locking brackets
Fig. 31-3 Warming rack locking bracket removal
Bracket
Remove screw
SERVICING AND CLEANING (Cont.)