Manualshelf

Installation Manual

ManualsBrandsFire Magic ManualsGrillsChoice Series 30 Inch Built-In Natural Gas Grill with 3 Standard Burners, 540 sq. inch Grilling Surface Size, Warming Rack, Analog Thermometer, Diamond Sear Cooking Grids, Flavor Grids, 90 Degree Double Walled Hood in Stainless Steel
21222324252627282930
29
CONTROL PANEL REMOVAL
Note: Wear heat-resistant gloves if necessary.
1. Turn the control knobs to the OFF position and turn
off the gas supply to the unit.
2. Remove the rubber grip from a control knob (see Fig.
29-1).
3. Insert the included .078" (2mm) hex key through the
small hole located on the side of the knob and loosen
the screw (see Fig. 29-2).
4. Pull the control knob from the stem to fully remove.
5. Repeat for the other knobs.
6. Remove the drip tray.
7. Using a Phillips screwdriver, unscrew and remove the
control panel fastener screws and washers (located on
the left and right front face of the control panel). See
Fig. 29-3. Retain the screws for later re-installation.
8. Carefully remove the control panel by lifting and pulling
the control panel from the frame (see Fig. 29-4).
Note: Ensure the cooking grid locking channel remains
attached to the control panel when reinstalling. See
INSTALLATION - SECURE THE COOKING GRIDS
section for details.
WARNING: During reinstallation: prior to opening the gas
shut-off valve, be sure the control knobs are
in the OFF position.
Rubber grip
Fig. 29-2 Loosen screw to free knob
Loosen screw
(inside hole)
with hex key
Fig. 29-3 Screws removal
Fig. 29-4 Control panel removal
Remove
control panel
Remove screws and washers
Cooking grid
locking channel
Fig. 29-1 Rubber grips removal
SERVICING AND CLEANING (Cont.)