Installation Manual

22
INSTALLATION (Cont.)
LOCK THE CONTROL KNOBS
1. Turn the control knobs to the OFF position and
turn off the gas supply to the unit.
2. Remove the rubber grip from the control knob (see
Fig. 22-1).
3. Insert the included .078" (2mm) hex key through
the small hole located on the side of the knob and
fully tighten the screw (see Fig. 22-2).
4. Replace the rubber grip.
5. Repeat this process for the remaining knobs.
INSTALL THE DRIP TRAY
Your grill includes a pack of four drip tray liners. Place
a liner into the drip tray as shown in Fig. 22-3, and fully
insert the drip tray into the bottom front of the control
panel.
Note: The liner must fit under the rear lip and two front
tabs found on the drip tray.
Fig. 22-2 Tighten screw to lock knobs
Fig. 22-3 Install drip tray
Liner
Fig. 22-1 Remove rubber grips
Rubber grip
Tighten screw
(inside hole)
with hex key