Installation Manual

19
INSTALLATION (Cont.)
Fig. 19-1 Household LP & Nat. gas diagram
Gas supply (NPT)
OFF
Gas supply
Shut-off valve (shown in-
line) must be within 6 feet
of the unit and must be
easily accessible
(Countertop)
Timer box
Flare-
to-NPT
adapter
Flex connector
(included)
Flex connector
(not included)
CONNECT THE GAS SUPPLY
To Connect To Propane Cylinder:
Read the safety warnings and follow the instructions in the
section SAFE USE AND MAINTENANCE OF PROPANE GAS
CYLINDERS.
Note: When a propane cylinder is installed inside of
the enclosure, the guidelines found in the GRILL
ENCLOSURE / VENTILATION REQUIREMENTS
section MUST be followed.
To Connect To Natural Or Household Propane Gas Supply:
CAUTION: Use only C.S.A. listed stainless-steel flex
connectors within the enclosure.
WARNING
A rubber or plastic connector will rupture or leak, resulting
in an explosion or serious injury if used inside the
appliance enclosure.
• Before connecting the gas supply to your appliance,
pressures MUST be tested and MUST NOT exceed 10.5"
w.c. for Nat. gas and 13" w.c. for L.P. gas. An additional
regulator may be required.
• Refer to the GAS SUPPLY PLUMBING REQUIREMENTS
section for all details on the gas supply and its setup.
1. Turn OFF the gas supply at the source.
2. Locate the flex connector attached to the grill, and route it
under the left side of the grill to the timer box area.
3. Using two wrenches, connect the flex connector coming
from the grill to the
1
/2" flare adapter labeled OUT. See
Fig. 19-1. Ensure the connection is tightened securely.
4. Connect gas source to IN: Using two wrenches, connect a
flex connector (not included) to the
1
/2" flare adapter labeled
IN. See Fig. 19-1. Ensure the connection is tightened securely.
5. Route the flex connector coming from the timer box to the
gas supply stub (see Fig. 19-1).
6. A shut-off valve is required within 6 feet of the unit and
must be easily accessible.
If shut-off valve is installed in-line:
• Install the supplied flare-to-NPT adapter to the gas
supply (NPT) using a pipe joint compound resistant to
all gasses (see Fig. 19-2, A). Tighten securely.
• Connect the flex connector to the adapter (see Fig.
19-2, A). Tighten securely.
If shut-off valve is connected to end of gas supply
stub:
• Connect the flex connector to the shut-off valve (flare)
(see Fig. 19-2, B). Tighten securely.
Fig. 19-2 Connecting to a gas line
Gas supply
(NPT)
Flex
connector
(from grill)
Flare-to-NPT
shut-off
valve*
(end of gas
supply)
NPT-to-NPT
shut-off
valve*
(in-line)
Gas supply
(NPT)
Flare-to-NPT
adapter
Flex
connector
(from grill)
* Shut-off valve: required, not included, must be within
6 feet of unit and must be easily accessible.
A B
-OR-