Installation and Operating Instructions

7
NO. L-C2-27409
Rev 4 - 0901121556
Doors and Drawers
The left top drawer (Fig. 7-1) is for tool/utensil
storage. The blender container and other such items
may be stored effectively in this drawer.
The right top drawer is for storage of clean ice. Open
the drawer, make sure the drain plug is in place (Fig.
7-2), and pour the ice into the basin. Close the
drawer to protect the ice from wind and debris and
to keep it shaded. Remove the drain plug to allow
melted ice to drain. Wipe out or clean as needed.
The two basins inside the door on the right of the
beverage center (stand-alone only) are for iced
beverage storage. The basins may be removed to
dump used ice ( Fig. 7-3) .
To remove a drawer; pull it completely out. Release
the drawer from the drawer slides by pressing the
black lever down on the right side, and up on the left
side (Fig 7-4). Then lift upward and outward on the
drawer until it comes free of the runners.
To re-attach a drawer; extend the drawer slides
completely and align the drawer into the slides, pushing
the drawer closed. Open the drawer to verify that it has
locked in place.
Both stand-alone doors are held in place magnetically
when closed.
Wine glass retainer (if equipped)
Place wine glasses as shown in Fig. 7-5. Do not force.
Using the waste basket (stand-alone only)
The rubber waste basket fi ts into the stainless-steel
loop attached to the inside of the left door (Fig. 7-6).
OPERATION (continued)
Fig. 7-2
Removing clean ice storage drain plug
Release drawer slider prior to removal
Fig. 7-4
Fig. 7-5
Glass storage racks under top (if equipped)
Fig. 7-6
Waste basket (Stand-alone only)
WARNING
Total weight on the upper storage
shelf must not exceed 35 lbs.
Removing basin
Fig. 7-3
Left storage drawer
Fig. 7-1