Installation and Operating Instructions

NO. L-C2-27409

Rev 4 - 0901121556

Install paper towel holder (stand-alone only)

Unpack the paper-towel holder hanger, squeeze the

open ends together slightly, and insert them into the

mounting bracket on the front right (Fig. 6-1).

Next, release the hanger so that the ends poke

out through the holes in the top and bottom of the

mount.

(Un)locking casters (stand-alone only)

To lock a caster press down on the side of the lever

with the word "OFF" stamped on it until it stops and

the caster will not turn. To unlock, press down on the

side stamped "ON."

Turning the light on and off (if equipped)

Note: The beverage center must be plugged in to a 110V

AC power source.

Locate the button underneath the right side of the

light panel. Press the button to turn on and off the

two halogen lights underneath the rack.

Using magnetic bottle opener

A magnetic bottle opener is located on the right side

drawer. To use simply insert the top of the bottle as

shown in Fig. 6-4 and pull the bottom of the bottle

downward until the cap is removed. The cap will then

stick to the magnet instead of falling to the ground.

Remove the cap from the magnet and discard.

ASSEMBLY (continued)

Fig. 6-3

Fig. 6-2

Caster in locked position (stand-alone only)

Using the light switch

Fig. 6-4

Magnetic bottle opener (right drawer)

OPERATION

Fig. 6-1

Paper towel holder (stand-alone only)