Installation Instructions and Owner's Manual

17
INSTALLATION (cont.)
INSTALL THE FLAVOR GRIDS
Place the fl avor grids directly onto the studs on the burners.
See Fig. 17-1. The slightly larger grids are designed to
be placed over the outside burners, and the slightly
smaller grid(s) over the inner burner(s). The avor
grids allow heat from the burners to be evenly distributed
throughout the cooking area.
INSTALL THE COOKING GRIDS
Using the grid lifter, place each cooking grid onto the front
and rear grid rests of the grill. See Fig. 17-2.
INSTALL THE DRIP TRAY
Your grill includes a pack of four drip tray liners. Place a
liner into the drip tray as shown in Fig. 17-3, and fully insert
the drip tray into the bottom front of the control panel.
Note: The liner must fi t under the rear lip and two front
tabs found on the drip tray.
Fig. 17-1 Install fl avor grids
Place onto studs
Fig. 17-3 Install drip tray
Liner
Fig. 17-2 Install cooking grids