Installation Instructions and Owner's Manual

16
LOCATION PREPARATION
Prepare a fl at, level surface capable of supporting the
weight of the stand-alone grill and convenient to the gas
supply if connecting to a gas line.
WHEELS AND CASTERS
To lock a caster press down on the side of the lever with
the word "ON" stamped on it until it stops and the caster
will not turn. To unlock, press down on the side stamped
"OFF."
INSTALL THE TOOL HOLDER AND PAPERTOWEL
HOLDER
The rectangular mounting bracket for the tool holder and
the paper towel holder come pre-attached to the sides of
the cart.
Unpack the holder portion, squeeze the open ends
together slightly, and install them into the mounting bracket
(see Fig. 16-2). Next, release the hanger so that the ends
extend out through the holes in the top and bottom of the
mounting bracket (Fig. 16-3, 16-4).
When not in use, the racks may be folded back against
the wall of the grill (Fig. 16-3, 16-4).
CONNECT THE GAS SUPPLY
For connecting a propane unit to a portable propane tank,
read the safety warnings and follow the instructions in the
section SAFE USE AND MAINTENANCE OF PROPANE
GAS CYLINDERS.
For household propane or natural gas units:
1. Turn OFF the gas supply at the source. The quick
disconnect hose is pre-installed on the valve manifold
at the manufacturer. Run the hose through the hole
in the bottom rear of the stand-alone unit, to the gas
supply.
2. A shut-off valve is required within 6 feet of the unit.
Connect the quick connect hose to the shut-off valve
OR gas supply using a pipe joint compound resistant
to all gasses (see
Fig. 16-5 ). Tighten securely.
3. Turn all burner valves to the OFF position. Turn the gas
supply on. Then carefully check all gas connections
for leaks with a brush and soapy water before lighting.
NEVER USE A MATCH OR OPEN FLAME TO TEST
FOR LEAKS.
INSTALLATION
INSTALLATION
Fig. 16-1 Lock/unlock wheels
Fig. 16-3 Tool holder detail
Fig. 16-4 Papertowel holder detail
Fig. 16-2 Install tool holder / papertowel holder
Fig. 16-5 Connecting to a gas line
Gas supply
Quick
connect hose
(coming from unit)
Shut-off valve
(required, not
included, must be
installed within 6
feet of the unit)
Quick connector
(can be connected
directly to gas supply
stub if shut-off valve
installed in-line)