Installation Guide

9
REV 7 - 1611280835
L-C2-306
ASSEMBLY AND INSTALLATION - STEP BY STEP
CAUTION: Island components are heavy. CAREFULLY
handle all components during assembly.
Note: Various DC430 and DC790 models are depicted
here. Your assembly may slightly vary depending on
model selected.
Important: DO NOT fully tighten any bolts until the
island base is leveled and squared. Hand
tighten until instructed to fully tighten.
Attach Levelers
1. Locate the island pieces in an appropriate location (refer
back to the LOCATION section if needed).
2. Carefully lay down all pieces that make up the island
base and attach the levelers (see Fig. 9-1).
Important: The levelers are required for ventilation and
leveling purposes.
Assemble Left Side and Rear Wall
DX430 Models (1 piece rear wall)
1. Orient the left side wall and rear wall as shown. Carefully
align the pilot holes, and insert the hardware (hardware
kit A) in the order shown. Hand tighten only. See Fig. 9-2.
DX790 Models (multi-piece rear wall)
1. Orient the left side wall and rear wall left piece as shown.
Carefully align the pilot holes, and insert the hardware
(hardware kit A) in the order shown. Hand tighten only.
See Fig. 9-2, A.
2. Install the column by placing its tabs between the rear
wall left and right pieces (see Fig. 9-2, B).
3. With the column in place, assemble the rear wall pieces.
Repeat the hardware installation process (hardware kit
A). Hand tighten only. See Fig. 9-2, C.
Assemble Right Side Wall and Install Outlet Box
1. Orient the right side wall and repeat the hardware
installation process (hardware kit A) for the bottom
hardware fi rst. Ensure the top pilot holes are also aligned.
Hand tighten only. See Fig. 9-3, A.
An outlet box assembly is provided and requires
installation. Assemble the box as shown, then repeat the
hardware installation process to secure both the top of
the right wall and the outlet box in place. Hand tighten
only. See Fig. 9-3, B and Fig. 9-4.
Note: Covers are provided for any outlets that will not be
used (if applicable).
ASSEMBLY AND INSTALLATION (Cont.)
Fig. 9-1 Attach levelers
Attach levelers to bottom of all walls
Hardware A:
Bolts x 2
Nuts x 2
Washers x 4
DX430
models
Fig. 9-2 Assemble left side and rear wall
DX790
models
Hardware A:
Bolts x 4
Nuts x 4
Washers x 8
(Hand
tighten)
B
C
Installation continued on next page
A
(Hand
tighten)
Fig. 9-3 Assemble right side wall and outlet box
A
B
Hardware A:
Bolts x 2
Nuts x 2
Washers x 4
(Hand tighten)
Fig. 9-4 Right side wall and outlet box installed
(Covers are
provided for any
outlets that will
not be used)