Owners Guide

REV 0 - 1802071430
L-C2-563
2
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
Timer
setting mark
(shown here
in OFF)
Time settings:
20-60 minutes
Fig. 2-1 1-Hour timer detail
Turn past
20 minutes
to activate
Timer
setting mark
(shown here
in OFF)
Time settings:
1-3 hours
Fig. 2-2 3-Hour timer detail
Turn past
1 hour to
activate
TIMER (1-hour model)
Open the shut-off valve located inside the box assembly and set
the dial (turn clockwise) to the desired time to shut off. The dial is
marked in 3 twenty minute increments (any position in between
is an estimate of that set time). The timer dial will auto rotate
(counter-clockwise) and will shut off the gas supply when the dial
reaches OFF (i.e. the time is completed).
Important: When using the timer for periods of less than twenty
minutes, you must fi rst set the dial to 20 minutes
(to activate), then return (counter-clockwise) to the
desired amount of time. This will ensure proper timer
operation. See Fig. 2-1.
TIMER (3-hour model)
Open the shut-off valve located inside the box assembly and set
the dial (turn clockwise) to the desired time to shut off. The dial
is marked in 3 one hour increments (any position in between is
an estimate of that hour). The timer dial will auto rotate (counter-
clockwise) and will shut off the gas supply when the dial reaches
OFF (i.e. the time is completed).
Important: When using the timer for periods of less than
one hour, you must fi rst set the dial to 1 hour (to
activate), then return (counter-clockwise) to the
desired amount of time. This will ensure proper timer
operation. See Fig. 2-2.
CAUTION: Always leave the shut-off valve in the closed position when not in use.
Note: Always instruct the end user on the safe operation of the outlet, timer valve, and gas connections.