Installation and Operating Instructions

12
CHECKING AND CONVERTING GAS TYPE
This barbecue comes from the factory confi gured
for one type of gas as marked on the label behind
the barbecue face plate.
Converting this barbecue to burn a different
type of gas requires a conversion kit from the
factory. The professional installer that converts
this barbecue to burn a different gas must
perform the following functions:
1. Change replaceable, brass gas orifi ces (included at
original shipping) on each burner to match the new
gas type (see PRODUCT DATA TABLE, Table 1).
2. Switch the convertible gas regulator (included
at original shipping) to match the new gas type
(see below).
3. Plumb the unit to the new gas supply.
4. Apply a new label behind the faceplate, indicating
the new gas the barbecue will burn (included
with conversion kit).
HAZARDOUS OVERHEATING WILL OCCUR IF A
NATURAL GAS ORIFICE IS USED WITH PROPANE
GAS. IF YOU ARE NOT SURE THE CORRECT
ORIFICES ARE INSTALLED, OR IF AN ORIFICE
CHANGE IS NECESSARY, REFER TO THE FOLLOWING
INSTRUCTIONS.
CAUTION: Make sure the barbecue is at a safe
temperature and isolated from gas and
electrical supplies before beginning the
tasks outlined below.
Note: The cooler the barbecue, the greater the
tolerances between the stainless steel parts,
and therefore, the easier to disassemble and
reassemble parts of the barbecue.
For your safety, exercise caution, and make sure you have
adequate hand protection, such as gloves, when handling
removable sheet metal parts of the barbecue.
THIS APPLIANCE REGULATOR IS RATED FOR
1
/
2
PSI MAXIMUM. IF YOUR GAS SUPPLY IS
GREATER THAN
1
/
2
PSI, AN ADDITIONAL REGULATOR MUST BE INSTALLED BEFORE THE
BARBECUE. SEE GAS SUPPLY REQUIREMENTS SECTION FOR PROPER GAS SUPPLY
PRESSURE.
CHECKING AND CONVERTING THE REGULATOR
Note: Each end of the plastic converter is engraved with either the letters NAT or
L.P. (propane) for the respective gases. When the converter is in the cap
and the cap is held uppermost, the letters seen indicate the gas that the
regulator is set up for.
To convert the regulator from one gas to another follow steps 1-4.
STEP 2:
Remove the converter (the
plastic stalk) by carefully
pulling it away from the center
of the cap (it will snap out of
its seating).
STEP 1:
Unscrew and remove the cap from the
regulator, extracting the converter.
Barbecue regulator:
note the cap on top
STEP 3:
Turn the converter around
and replace carefully into the
center of the cap (it will snap
into place). Check that you can
read the type of gas the unit is
set for.
STEP 4:
Replace the unit into the
regulator and screw down
until snug.
Read gas
type here
WARNING
WARNING