Users Manual

Fine Gain Adjust
-5 to +5dB
If filtering is enabled, gain of each channel can be
fine adjusted
Power indicator
---
Level of each channel, measured according to its
bandwidth filter, is shown in dBm units. Led
indicator shows if levels exceeds squelch
threshold (green) or not (yellow).
AGC
---
Show gain reduction to prevent overloading in
AGC per channel
Squelch enable
control
Enabled / disabled
Enabling this control, repeater does not transmit
in each channel if RF input power do not exceed
the threshold level configured according to next
row
Squelch threshold
control
-110dBm to -70dBm
If squelch is enabled, input levels below this
threshold are not transmitted.
Filtering enable
Enabled / disabled
Filtering option can be bypassed. If filtering is
disabled, fine gain adjustments and squelch
options are ignored
o Remote RF Input parameters. Next table describes information of this frame:
Parameter
Range
Description
Broad band level
---
This indicator shows input level measured in UL
band
Overflow
Grey: normal state /
Red: alarm state
This indicator shows overflow on input circuitry is
occurring.
Uplink gain from
remote to master
--
Shows system uplink gain for each remote. Can
be calculated as:
G_UL (dB) = 80 – AttOutMaster(dB)
o Remote RF Output parameters. Next table describes information of this frame:
Parameter
Range
Description
Output power
level
---
This indicator shows the PA output power
Confidential