Users Manual

o Date & Time (for units with Ethernet supervision): page to modify real time clock. When the
repeater is not powered, this clock runs with a voltage supply provided by a 3V lithium battery,
button type of 20mm (CR2032) with 220mA·h. This suffices for at least half year. When the
repeater is powered, no current is drained from the battery. So, actual battery life will depend
on repeater usage. For battery replacement, please locate battery holder between USB and
Ethernet connectors on main board. Battery positive side is UP, i.e. on holder clip.
After clicking on “Apply Changes” link, next message will appear, warning the user that system needs to
be rebooted.
 Configuration
o Apply Changes: as it is said above, this link is used to load changes to the repeater, in
configuration, tag, IP, password and date and time menus. After any configuration change, web
page will show and icon that allows user to know if configuration has been successfully applied:
o Reload Settings: clicking this link, repeater configuration data is refreshed.
 Version: shows hardware, firmware and software versions of repeater and serial number.
RF parameters description (Digital Master)
“Status” menu shows whole RF configuration and RF and optical links monitoring data that are distributed along the
webpage.
The first frame called “MASTER” is placed in top of webpage, showing configuration of digital master unit. Below this,
some frames titled “REMOTE 1”, “REMOTE 2”... . There is one for each remote unit connected to the master, and
configuration and status information related to each remote can be viewed. Next figures show these frames:
Confidential