Users Manual

PA Enable
This control enables / disables PA UL:
Green button and label “ON” means that PA is enabled,
red button and label “OFF” means that PA is disabled
RF Output Power
Shows instantaneous RF output power at UL band
Overload UL
This alarm indicates that Signal Booster is being
overloaded at UL band, due to very high RF input level
PA Status
PA status alarm indication based on current
consumption
All Filters Same BW
If enabled, any change of bandwidth filter of any
enabled filter will be applied to all UL filters
o Main downlink control: parameters regarding to downlink band. They are
almost equal to uplink band.
Downlink frame
Parameter
Description
Main Gain
Set maximum gain of Signal Booster at DL band. Range
can vary between models.
Power Limit
Set maximum output power of Signal Booster at DL band.
System automatically will apply a correction to share this
limit between the active channels. For instance, +36dBm
band limit means +30dBm maximum output power per
channels for 4 active channels. Range can vary between
models depending on rated power.
Squelch Enable
Enabling this control, Signal Booster does not transmit in
each channel if RF input power do not exceed the
threshold level configured according to next row.
Squelch Threshold
If squelch is enabled, input levels below this threshold are
not transmitted.
PA Enable
This control enables / disables PA DL:
Green button and label “ON” means that PA is enabled,
red button and label “OFF” means that PA is disabled