Users Manual

o Read-only community and read-write community: set passwords for
SNMP agent (typically "public" / "private")
o Watchdog Period: time in minutes without external IP access to the
device (HTTP, SNMP or PING) after which the embedded Ethernet
module will reboot just in case it were stuck. It does not affect RF
functioning. Default value is 1440 minutes, i.e. one day.
o Ethernet RESET: resets Ethernet module.
o Delete All Traps: clear all alarm conditions and sets trap counter to zero
o Trap community: set trap community for each connection to SNMP
Manager
o Trap port: set UDP port for SNMP trap sending. Default standard port is
162. SNMP polling is done through standard port nr. 161.
o Trap repetition: set number of traps that SNMP agent will send every
time that alarm conditions vary. Maximum number is five repetitions and
the time lapse between them is 10 seconds.
o Manager Enable: enables each connection to SNMP Manager
independently. If enabled, traps will be sent to manager IP address set in
IP section.
o Keep-Alive period: Keep-Alive traps can be sent periodically with the
purpose of letting the SNMP manager know that the agent is working.
The time in minutes between these traps is the Keep-Alive period.
Default period is 60 minutes. A setting o 0 disables sending these traps.
These traps are not affected by the Trap Repetition mentioned before.
 Configuration
o Apply Changes: as it is said above, this link is used to load changes to the
Signal Booster, in configuration, tag, IP, password and date and time
menus. After any configuration change, web page will show and icon that
allows user to know if configuration has been successfully applied: