Users Manual

Safety
Caution!
This manual lists a set of rules and warnings to be accomplished when installing,
commissioning and operating a Signal Booster / Master / Remote Unit from FIPLEX.
Any omission may result in damage and/ or injuries to the System and/or the
System Operators or Users.
If an instruction is not clear or you consider is missing, please contact immediately
to Fiplex.
See www.fiplex.com for contact information.
Dangerous Voltage Warning
Any personnel involved in installation, operation or service of Fiplex Signal Boosters
/ Masters / Remotes must understand and obey the following:
The power supply unit supplied from the main power contains dangerous voltage
level, which can cause electric shock. Switch the main power off prior to any work
in such equipment. Any local regulations are to be followed when servicing Signal
Boosters / Masters / Remotes. Authorized service personnel only are allowed to
service repeaters while the main is switched on.
Radiation Hazard Warning
Any Signal Booster / Master / Remote, including this unit, will generate radio signals
and thereby give rise to electromagnetic fields that may be hazardous to the health
of any person who is extensively exposed to the signals at the immediate proximity
of the Signal Booster / Master / Remote and the Antennas.
R&TTE Compliance Statement
This equipment complies with the appropriate essential requirements of Article 3 of
the R&TTE Directive 1999/5/EC.
Station Ground
BTS chassis, Signal Booster / Master / Remote feeders, donor antenna, service
antenna/s and auxiliary equipment (splitters, tabs, .etc) are required to be bonded
to protective grounding using the bonding stud or screw provided with each unit.
Electrostatic Discharge
Static electricity means no risk of personal injury but it can severely damage
essential parts of the Signal Booster / Master / Remote, if not handled carefully.
Parts on the printed circuit boards as well as other parts in the Signal Booster /
Master / Remote are sensitive to electrostatic discharge.
Never touch printed circuit boards or uninsulated conductor surfaces unless
absolutely necessary.
If you must handle printed circuit boards or uninsulated conductor surfaces, use
ESD protective equipment, or first touch the Signal Booster / Master / Remote
chassis with your hand and then do not move your feet on the floor.
Never let your clothes touch printed circuit boards or uninsulated conductor
surfaces.