Users Manual

The desired carrier frequencies of the downlink band, are to be typed in the text
area of this window expressed in MHz. The tool will try to enable as many filters
of 90KHz bandwidth as necessary for all carriers, using a fine gain of 0dB by
default. This is trivial when carrier frequencies are sufficiently separated apart.
For instance:
The button "Compute Configuration Proposal" shows the computed filter
frequencies in another text area and, if accepted, the button "Apply Proposal"
would actually perform the configuration change.
However, for carrier frequencies that come in packets, the filter frequencies
should not be set too close because the overall response would be distorted.
Depending upon signal modulation, that response distortion might not have any