Users Manual

Figure: Secure Signal Booster / Master / Remote cover
Use of Liquid Tight Conduit
Mounting Cabinet FCR012
The unit has available a Liquid Tight Conduit Fitting connector for ¾” tubes. The
unit as standard has the connector installed, so if the user requires to use this
connector, if available, the NFPA cables, Ethernet, DC or AC cables can be routed
through this connector.
Figure: AC Routing through cable gland or conduit connector
If the is not going to use Liquid Tight Conduits, then the connector should be
replaced by the provided sealing cup.
Figure: Remove the conduit connector