User's Manual

UM-0101-01.09 – November 2009

Part 2 SOFTWARE

4. Installation

The following section will describe the steps to be followed in order to install and use the pFOMS

software with your Fiplex repeater.

1. Execute the Fiplex Portable Foms installer and choose the default path “C:\program

files\fiplex”.

Please do not change this location.

2. Turn on the Repeater

BE SURE THAT “TO MOBILE” AND “TO BASE” PORTS ARE PROPERLY LOADED

EITHER WITH 50 OHMS DUMMY LOADS, OR RADIATING SYSTEM.

3. Plug in USB cable to USB male connector labeled as “COMM”. Repeater HW will trigger the

installation of its driver, which is a COM port emulator.

“New hardware found” advice should be noticed.