MV Series Motors Operation & Parts Manual Models M3V, M5V, M5V-US For use with M3V s/n 101057 & below, M3V-US s/n 103013 & below, M5V & M5V-US s/n 102972 & below.
Introduction This manual pertains to drum pump motors MV Series. Finish Thompson, Inc. thanks you for choosing our products. We believe the use of our products will be fully satisfactory. When properly installed and operated, your Finish Thompson motor and pump will provide long, trouble-free service; therefore please read this manual carefully before carrying out any operations on the pump-motor unit. Any use other than that described herein is considered incorrect and; consequently, Finish Thompson, Inc.
WARRANTY, GENERAL TERMS & CONDITIONS 1. The following terms and condition apply to the sale of machinery, components and related services and products, of Finish Thompson Inc. (hereinafter “the products”). 2. Finish Thompson Inc. (the manufacturer) warrants only that: a.) b.) . . . c.) . . its products are free of defects in material, design and workmanship at the time of original purchase its products will function in accordance with Finish Thompson Inc. operation manuals; Finish Thompson Inc.
SAFETY 1. Introduction This manual contains all the information needed for the correct installation, use and maintenance of your new Finish Thompson motor. It should be read and understood by all the personnel involved in installation, operating and servicing of the pump before it is started. 2. Operator Qualification and Training The personnel in charge of the installation, operation and maintenance of the pump unit we produce must be qualified and able to perform the operations described in this manual.
INSTALLATION 1. Unpack motor from carton. Check for shipping damage. If damage is detected, save the packaging and notify the carrier immediately. 2. Loosen the nut on the motor housing by turning it counterclockwise (as viewed from the bottom of the motor). Note that the nut remains on the motor even when loosened. See figure 1. 3. Looking into the bottom/drive-end of the motor, align the coupling half with the coupling half orientation of the pump.
OPERATION The MV Series motors incorporate an ON/OFF switch as well as a Variable Speed Control. When operating the MV Series for the first time it is recommended to turn down the speed control (Counter Clockwise) to the lowest setting. Make sure the discharge hose is properly secured. Turn on the motor with the ON/OFF switch & adjust the speed control to the desired flow rate. Both of these operations can be done with the same hand being used to support the pump utilizing the thumb.
PARTS Note: Housing Repair Kit includes handle, cover, base, nut and labels.
