Datasheet

FTLX8571D3BCV Product Specification – March 2009
© Finisar Corporation -March 2009 Rev. B Page 3
II. Absolute Maximum Ratings
Exceeding the limits below may damage the transceiver module permanently.
Parameter Symbol Min Typ Max Unit Ref.
Maximum Supply Voltage Vcc -0.5 4.0 V
Storage Temperature T
S
-40 85
°C
Case Operating Temperature T
A
0 70
°C
Relative Humidity RH 0 85 % 1
Notes:
1. Non-condensing.
III. Electrical Characteristics (T
OP
= 0 to 70 °C, V
CC
= 3.14 to 3.46 Volts)
Parameter Symbol Min Typ Max Unit Ref.
Supply Voltage Vcc 3.14 3.46 V
Supply Current Icc 250 mA
Transmitter
Input differential impedance R
in
100
Ω
1
Differential data input swing Vin,pp 180 700 mV 2
Transmit Disable Voltage V
D
2 Vcc V
Transmit Enable Voltage V
EN
Vee Vee+ 0.8 V
Receiver
Differential data output swing Vout,pp 300 850 mV 3
Data output rise time, fall time t
r
28 ps 4
LOS Fault V
LOS fault
2 Vcc
HOST
V 5
LOS Normal V
LOS norm
Vee Vee+0.8 V 5
Power Supply Noise Tolerance VccT/VccR Per SFF-8431 Rev 3.0 mVpp 6
Notes:
1. Connected directly to TX data input pins. AC coupling from pins into laser driver IC.
2. Voltage swing for 1G operation is equivalent to voltage swing in 10G operation (SFF-8431 Rev
3.0).
3. Into 100Ω differential termination. Voltage swing for 1G operation is equivalent to voltage swing
in 10G operation (SFF-8431 Rev 3.0).
4. 20 – 80 % . Measured with Module Compliance Test Board and OMA test pattern. Use of four 1’s
and four 0’s in sequence in the PRBS^9 is an acceptable alternative. SFF-8431 Rev 3.0
5. LOS is an open collector output. Should be pulled up with 4.7kΩ – 10kΩ on the host board.
Normal operation is logic 0; loss of signal is logic 1. Maximum pull-up voltage is 5.5V.
6. Testing methodology per SFF-8431. Rev 3.0