Datasheet

FTLF8529P3BCV Pluggable SFP+ Product Specification – November, 2011
© Finisar Corporation Nov 15, 2011 Rev. A.0 Page 4
III. Electrical Characteristics (T
c
, V
CC
= 3.15 to 3.46 Volts)
Parameter Symbol Min Typ Max Unit Ref.
Supply Voltage Vcc 3.15 3.46 V
Supply Current Icc 290 mA 1
Transmitter
Input differential impedance R
in
100
Ω
2
Single ended data input swing Vin,pp 90 800 mV
Transmit Disable Voltage V
D
2 Vcc V 3
Transmit Enable Voltage V
EN
Vee Vee+ 0.8 V
Receiver
Single ended data output swing Vout,pp 185 425 mV 4
LOS Fault V
LOS faul
t
2 Vcc
HOST
V 5
LOS Normal V
LOS norm
Vee Vee+0.8 V 5
Power Supply Rejection PSR 100 mVpp 6
Deterministic Jitter @ 8.5 Gb/s RX DJ 0.420 UI
Deterministic Jitter @ 14.025 Gb/s RX DJ 0.220 UI
Notes
:
1. With established link
2. Connected directly to TX data input pins. AC coupling from pins into laser driver IC.
3. Or open circuit.
4. Into 100 ohms differential termination.
5. LOS is an open collector output. Should be pulled up with 4.7k – 10kohms on the host board. Normal
operation is logic 0; loss of signal is logic 1. Maximum pull-up voltage is 5.5V.
6. Receiver sensitivity is compliant with power supply sinusoidal modulation of 20 Hz to 1.5 MHz up to
specified value applied through the recommended power supply filtering network.