Datasheet

FTLF1428P2BNV Product Specification – October 2008 F i n i s a r
© Finisar Corporation October 29, 2008 Rev. C1 Page 4
Notes
:
1. Non-condensing.
2. Module power consumption never exceeds 1W.
3. AC coupled.
4. Or open circuit.
5. Into 100 ohm differential termination.
6. 20 – 80 %.
7. LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
8. All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5
MHz up to specified value applied through the power supply filtering network shown on page 23 of the
Small Form-factor Pluggable (SFP) Transceiver MultiSource Agreement (MSA)
6
, September 14, 2000.
The Power Supply Rejection applies for a supply voltage range of 3.1 to 3.6 V.
9. Measured with DJ-free data input signal. In actual application, output DJ will be the sum of input DJ
and
Δ DJ.
10. For 8.5 Gb/s operation, Deterministic Jitter and Total Jitter are not specified per FC-PI-4 Rev 8.00.
Jitter values for gamma T and gamma R are controlled by TDP and stressed receiver sensitivity.
IV. Optical Characteristics (T
OP
= -5 to 85 °C, V
CC
= 3.00 to 3.60 Volts)
Notes:
1. Class 1 Laser Safety per FDA/CDRH and EN (IEC) 60825 regulations.
2. High Bandwidth Mode. Class 1 Laser Safety per FDA/CDRH and EN (IEC) 60825 regulations.
3. Low Bandwidth Mode. Class 1 Laser Safety per FDA/CDRH and EN (IEC) 60825 regulations.
4. Also specified to meet curves in FC-PI-4 Rev 8.00
1
Figures 21, 22, and 23, which allow trade-off
between wavelength, spectral width and OMA.
5. Equivalent extinction ratio specification for Fibre Channel. Allows smaller ER at higher average
power.
6. For 8.5 Gb/s operation, Jitter values for gamma T and gamma R are controlled by TDP and stressed
receiver sensitivity.
7. Unfiltered, 20-80%. Complies with IEEE 802.3 (Gig. E), FC 1x and 2x eye masks when filtered.
8. Measured with conformance signals defined in FC-PI-4 Rev. 8.00 specifications. Value in OMA.
Measured with PRBS 2
7
-1 at 10
-12
BER.
Parameter Symbol Min Typ Max Unit Ref.
Transmitter
Output Opt. Power, 8.5 Gb/s P
O,RH
-8.4 +0.5 dBm 2
Output Opt. Power, 2.125, 4.25 Gb/s P
O,RL
-8.4 -3 dBm 3
Optical Wavelength
λ
1285 1345 nm 4
Spectral Width
σ
1 nm 4
Optical Modulation Amplitude OMA 290
μW
4,5
Transmitter and Dispersion Penalty, 8.5 Gb/s TDP 3.2 dB 6
Optical Rise/Fall Time, 2.125, 4.25 Gb/s t
r
/ t
f
90 ps 7
RIN -128 dB/Hz
Receiver
Unstressed Receiver OMA Sensitivity, 8.5 Gb/s R
SENSr
0.042 mW 8
Unstressed Receiver OMA Sensitivity, 4.25 Gb/s R
SENS4
0.029 mW 8
Unstressed Receiver OMA Sensitivity, 2.125 Gb/s R
SENS2
0.015 mW 8
Average Received Power Rx
MAX
+0.5 dBm
Optical Center Wavelength
λ
C
1260 1360 nm
Return Loss 12 dB
LOS De-Assert LOS
D
-19 dBm
LOS Assert LOS
A
-30 dBm
LOS Hysteresis 0.5 dB