Datasheet

FTLF1424P2xCL and FTLF1424P2xCV SFP Product Specification – December 2006 F i n i s a r

11. Measured with conformance signals defined in FC-PI-2 Rev. 10.0 specifications. Represents

sensitivity based on OMA spec, as corrected to incoming Extinction Ratio of 13 dB (for example, at

5.75dB incoming extinction ratio, an OMA of 0.029 mW corresponds to -16 dBm sensitivity).

Measured with PRBS 2

-1 at 10

-12

BER .

12. Rate Selectable version in low bandwidth mode with minimum 9dB extinction ratio.

13. Rate Selectable version in low bandwidth mode.

14. Rate Selectable version in high bandwidth mode.

V. General Specifications

Parameter Symbol Min Typ Max Units Ref.

Data Rate BR 1062 4250 Mb/sec 1

Bit Error Rate BER 10

-12

Max. Supported Link Length on

9/125 μm SMF @ 4X Fibre Channel

MAX1

Max. Supported Link Length on

9/125μm SMF @ 1X and 2X Fibre

Channel

MAX2

30 km 3

Max. Supported Link Length on

9/125μm SMF @ Gigabit Ethernet

MAX3

30 km 3

Notes:

1. Gigabit Ethernet and 1x/2x/4x Fibre Channel compliant.

2. Tested with a PRBS 2

-1 test pattern.

3. Distances are based on FC-PI-2 Rev. 10.0 and IEEE 802.3 standards.

VI. Environmental Specifications

These Finisar 1310nm Commercial Temperature SFP transceivers have an operating

temperature range from –10°C to +70°C case temperature.

Parameter Symbol Min Typ Max Units Ref.

Case Operating Temperature T

-10 70 °C

Storage Temperature T

sto

-40 85 °C

VII. Regulatory Compliance

Finisar transceivers are Class 1 Laser Products and comply with US FDA regulations.

These products are certified by TÜV and CSA to meet the Class 1 eye safety

requirements of EN (IEC) 60825 and the electrical safety requirements of EN (IEC)

60950. Copies of certificates are available at Finisar Corporation upon request.