Datasheet

FTLF1424P2xCL and FTLF1424P2xCV SFP Product Specification – December 2006 F i n i s a r
II. Absolute Maximum Ratings
Parameter Symbol Min Typ Max Unit Ref.
Maximum Supply Voltage Vcc -0.5 4.5 V
Storage Temperature T
S
-40 85
°C
Case Operating Temperature T
OP
-10 70
°C
Relative Humidity RH 0 85 % 1
III. Electrical Characteristics (T
OP
= -10 to 70 °C, V
CC
= 3.00 to 3.60 Volts)
Parameter Symbol Min Typ Max Unit Ref.
Supply Voltage Vcc 3.00 3.60 V
Supply Current Icc 200 300 mA
Transmitter
Input differential impedance R
in
100
Ω
2
Single ended data input swing Vin,pp 250 1200 mV
Transmit Disable Voltage V
D
Vcc – 1.3 Vcc V 3
Transmit Enable Voltage V
EN
Vee Vee+ 0.8 V
Transmit Disable Assert Time 10 us
Receiver
Single ended data output swing Vout,pp 250 800 mV 4
Data output rise/fall time < 4.25 Gb/s t
r,
t
f
175 ps 5
Data output rise/fall time = 4.25 Gb/s t
r,
t
f
120 ps 5
LOS Fault V
LOS fault
Vcc – 0.5 Vcc
HOST
V 6
LOS Normal V
LOS norm
Vee Vee+0.5 V 6
Power Supply Rejection PSR 100 mVpp 7
Deterministic Jitter Contribution
< 4.25 Gb/s
RX
Δ
DJ
51.7 ps 8
Total Jitter Contribution < 4.25 Gb/s
RX
Δ
TJ
122.4 ps
Deterministic Jitter Contribution
= 4.25 Gb/s
RX
Δ
DJ
25.9 ps 8
Total Jitter Contribution = 4.25 Gb/s
RX
Δ
TJ
61.2 ps
Notes:
1. Non-condensing.
2. AC coupled.
3. Or open circuit.
4. Into 100 ohm differential termination.
5. 20 – 80 %
6. LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
7. All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5
MHz up to specified value applied through the power supply filtering network shown on page 23 of the
Small Form-factor Pluggable (SFP) Transceiver MultiSource Agreement (MSA)
1
, September 14, 2000.
The Power Supply Rejection applies for a supply voltage range of 3.15 to 3.6 V.
8. Measured with DJ-free data input signal. In actual application, output DJ will be the sum of input DJ
and DJ.
Δ
© Finisar Corporation December 18, 2006 Rev A Page 3