Datasheet

FTL-1319-3D Long-Wavelength GBIC Specification – November 2007 F i n i s a r
© Finisar Corporation November 16, 2007 Rev. C3 Page 5
V. Optical Parameters
Parameter Symbol Min Typ Max Units Notes/Conditions
TRANSMITTER CHARACTERISTICS
Transmitter Center Wavelength
λ
c
1270 1310 1355 nm
Transmitter Spectral Width
Δλ
RMS
4 nm RMS. Also meets
curves in FC-PI 10.0
Figures 18.
Transmitter Optical Output Power P
out
-9 -6 -3 dBm Average power coupled
into single mode fiber
Transmitter Extinction Ratio OMI 9 dB
Transmitter Eye Opening -- 60 % Conforms to IEEE
802.3 and Fibre
Channel Eye Masks
Transmitter Rise/Fall Time tr /tf 260 ps 20%-80% differential
unfiltered
Total Transmitter Jitter 160 ps Peak to peak, filtered
Relative Intensity Noise RIN -120 dB / Hz
RECEIVER CHARACTERISTICS
Optical Input Wavelength
λ
in
1270 1355 nm
Receiver Reflectance R
RX
-14 dB
Optical Input Power (1.25GB/s) P
in
-19 -3 dBm
Optical Input Power (1.0625Gb/s) P
in
-20 -3 dBm
BER < 10
-12
w/ PRBS
2
7
- 1 test pattern
Total Receiver Jitter 160 ps Peak to peak, filtered in
loopback
Note: Parameters are specified over temperature and voltage, at end of life unless otherwise noted.
Table 6. O
p
tical
p
arameters
VI. General Specifications
Parameter Symbol Min Typ Max Units Notes/Conditions
Data Rate BR 1.25
1.0625
Gb/sec Fibre Channel, IEEE 802.3
Compatible
Fiber Length L 10,000 m
9μm Core Single Mode Fiber
Fiber Length L 550 m
50μm 500MHz-km Fiber
Fiber Length L 275 m
62.5μm 200MHz-km Fiber
Table 7. General specifications