Use And Care Manual

12
ASSEMBLY
BREAKING IN THE PUMP
See Figures 4 - 5.
Check and tighten all bolts, fittings, etc.
Turn the pressure regulator knob fully clockwise to
open the air flow.
Place the switch in the OFF (O) position and plug in the
power cord.
Open the drain valves completely.
Turn the air compress ON ( l ) and run the air
compressor for 10 minutes to break in pump parts.
Place the switch in the OFF (O) position.
Close the drain valves.
PRESSURE
REGULATOR
KNOB
ON/OFF
SWITCH
Fig. 4
Fig. 5
DRAIN VALVE
(open)
DRAIN VALVE
(closed)
Fig. 3
ATTACHING HOSE
See Figure 3.
Insert the hose into the quick coupler already installed
on the compressor (Fig. 3).
Firmly grasp the open end of the hose; hold facing
away from yourself and others.
WARNING:
Do not attach any tools to the open end of the hose until
start-up has been completed.