Use And Care Manual

13
ASSEMBLY
WARNING:
Do not attach any tools to the open end of the hose until
start-up has been completed.
ATTACHING HOSE AND QUICK COUPLER
See Figure 4 - 5.
Make sure the air compressor is off and unplugged.
Rotate pressure regulator knob fully counterclockwise.
Apply one layer of thread sealing tape to the threaded
end of the male coupler and insert into the air outlet
port on the compressor (Fig. 4).
NOTE: Be careful not to allow threads to become
cross-threaded.
At this point insert the hose into the quick coupler
already installed on the compressor (Fig. 5).
Firmly grasp the open end of the hose; hold facing
away from yourself and others.
BREAKING IN THE PUMP
See Figure 6 - 7.
Check and tighten all bolts, fittings, etc.
Turn the pressure regulator knob fully clockwise to
open the air flow.
Place the switch in the OFF (O) position and plug in the
power cord.
Open the drain valve completely.
Turn the air compress ON ( l ) and run the air
compressor for 10 minutes to break in pump parts.
Place the switch in the OFF (O) position.
Close the drain valve.
ASSEMBLY
AIR OUTLET
FITTING
MALE
COUPLER
Fig. 4
DRAIN VALVE
Fig. 7
QUICK
COUPLER
HOSE
Fig. 5
REGULATOR
PRESSURE
GAUGE
PRESSURE
REGULATOR
KNOB
AIR
OUTLET
ON/OFF
SWITCH
Fig. 6
TANK
PRESSURE
GAUGE
SAFETY
VALVE