User Manual

9
R/C Combat Robot Kit | Viper
4. The power switch comes
with a female JST lipoly
battery connector plus
one red and one black
wire.
5. The red/black
wires are plugged into
the red/black terminal
blocks. Plug the red/
black wires from both
tinyESCs into these
terminal blocks too.
Note:
This switch is wired so that rechargeable batteries
can be charged through it (see page 19). Because both
positive and negative battery leads are in this switch,
do not
use a solid metal rod in place of a lost power plug!
Use only a “3.5mm Mono Headphone Plug” or you will
cause a short circuit.
Assembling The Viper
Assembling The Viper
| FingerTech Robotics