User Manual

16
Viper | R/C Combat Robot Kit
18. Test the drive motors.
19. When everything is running correctly, turn the
robot off by reinserting the power plug.
Don’t forget to turn the transmitter off too.
Assembling The Viper
The transmitter has been preprogrammed with
Channels 1 and 2 mixed for single-stick driving.
With the robot facing away from you, move the
right stick up. Both motors should turn forward.
Moving the stick to the right should reverse the
right motor and vice versa for the left. If either
motor turns the wrong way, see the
troubleshooting section.
If the motors are spinning while not pressing the
transmitter sticks, adjust the Trim levers on the
transmitter (located just beside the stick) until
the motors stop. Trims are for fine adjustments.
FingerTech Robotics | Assembling The Viper