User Manual

10. Tighten the Blade Hub onto the flat spot of the motor shaft with the Viper’s 5/64” hex
wrench. Use threadlock on the setscrew to keep the blade from coming off. Leave just
enough gap to fit your 1” wrench in after.
11. Secure your blade in the Blade Hub. Use 1” and 15/16” wrenches to tighten the blade hub
after threadlock has been applied. Tighten well - you don’t want it to come off!
12. Reattach the top and front armor panels.
13. Use a small C-clamp to secure the weapon whenever it is not inside the arena. Remove
only once the transmitter and robot are powered up and communicating properly.
14. All done! Use this spinner to destroy your opponents!
Visit www.FingerTechRobotics.com for more upgrade ideas!