User Manual

Kit Includes:
1 1100KV Brushless Motor 1 FingerTech Blade Hub
1 12A Brushless Controller 4 M3 Phillips Screws
Not Included:
- 15/16” (or 24mm) Wrench - Phillips Screwdriver
- 1” (or 25mm) Wrench - Twist-ties
- Weapon Blade - Safety C-clamp
- Threadlock liquid (medium strength)
This robot kit can be dangerous if not used properly. Never spin the blade outside
of an arena or safety enclosure. If testing the motor, remove the blade.
1. Remove the top and front armor
from your Viper kit.
2. Mount the Brushless Motor using
four M3 Phillips screws and
threadlock liquid.
3. Plug the Motor Controller into the
Throttle channel (Ch3) of your
receiver.
4. Plug the red/black wires of the
Motor Controller into the red/
black terminal blocks of your Viper.
5. Plug the three Motor Controller
output wires into the Brushless
Motor.
6. Secure the Motor Controller. Make sure to keep all wires from touching the spinning motor.
Twist-ties can be helpful.
7. With wheels up, power on the transmitter and robot. The Motor Controller plays three
tones then beeps to indicate battery voltage—2 beeps for 7.4V. If you hear a repeating
beep, it is because the transmitter throttle stick is not safely all the way down.
8. Move the throttle stick up until the motor spins. Check the direction. If it does not spin
clockwise, swap any two of the three motor wires and the direction will reverse. Power off
the robot and transmitter.
V i p e r S p i n n e r
V i p e r S p i n n e r
A d d
A d d
-
-
O n K i t
O n K i t
Visit www.FingerTechRobotics.com for more upgrade ideas!

Summary of content (2 pages)