Owner manual

6
1
2
3
4
OTHER FEATURES
You will find a buzzer, 4 LED indicators, and a door lock timer on the
board. Check and set each of them accordingly after powering up the
system.
1
You will hear the buzzer beep to indicate:
• Unlocked Door (Short buzz)
Door is unlocked and access granted (during verification or pressing push
release button).
• Over Voltage (Non-stop buzzing after startup)
Over voltage of power input (Stop the power supply to the system immedi-
ately and check the input voltage, consult [e-mail])
2
Adjust the door lock timer for a longer or shorter unlocking time period
by turning the screw clockwise. Count the LED blinks after turning it. Each
blink represents 1 second and the recommended time period is 5 seconds (5
blinks).
3
Select the type of door lock to use, NO type or NC type.
• PIN 1&2 – NO Type door lock system.
• PIN 2&3 – NC Type door lock system (default)
4
The LED lights up to indicate the following:
• EM lock LED - The EM lock system is charged up and working properly.
• Status LED - The overall system is working properly.
Note: Contact [e-mail] if either of the above LED lights are not
lit up.
• Bat Low LED - The battery is weak and needs to be charged or replaced.