User's Manual

Version 1.2 ©Copyright 2010, Ambient LLC. All Rights Reserved. Page 12
4.6.2 SensorAccuracyNote
Verify the temperature values match closely with the console and sensor array in the same location
(about 10 apart). The sensors should be within 4°F (the accuracy is ± 2°F).
Allow about 30 minutes for both sensors to stabilize.
4.6.3 Viewingthe3SensorChannels
To view the 3 sensor channels, select the CH/+ button. The minimum and maximum can be viewed
for each channel as specified in Section 4.3.
If the sensor communication has been lost (blank display where temperature and humidity are
displayed), hold the CH/+ key for 3 seconds to re-aquire the current channel sensor signal. If you
have additional remote sensors, hold the CH/+ key for 5 seconds to re-acquire all of the sensor
signals.
5. GlossaryofTerms
Term Definition
Absolute Barometric
Pressure
Relative barometric pressure, corrected to sea-level. To compare
pressure conditions from one location to another, meteorologists correct
pressure to sea-level conditions. Because the air pressure decreases as
you rise in altitude, the sea-level corrected pressure (the pressure your
location would be at if located at sea-level) is generally higher than your
measured pressure.
Accuracy Accuracy is defined as the ability of a measurement to match the actual
value of the quantity being measured.
HectoPascals (hPa) Pressure units in SI (international system) units of measurement. Same
as millibars (1 hPa = 1 mbar)
Hygrometer A hygrometer is a device that measures relative humidity. Relative
humidity is a term used to describe the amount or percentage of water
vapor that exists in air.
Inches of Mercury (inHg) Pressure in Imperial units of measure.
1 inch of mercury = 33.86 millibars
Range Range is defined as the amount or extent a value can be measured.
Relative Barometric
Pressure
Measured barometric pressure relative to your location or ambient
conditions.
6. Specifications
6.1WirelessSpecifications
Line of sight wireless transmission (in open air): 300 feet
Frequency: 433 MHz
Update Rate: 60 seconds