User Manual

Version 2.0 Page 19
4.8.7 Resynchronizing Lost Sensor
If the signal is lost between the remote sensor (or transmitter) and the display console (or the
receiver), to resynchronize, while in normal mode, Press and hold SET/CH and TEMP/+ button
for 5 seconds, to register the outdoor transmitter. The sensor search icon will flash.
Please wait several minutes for the remote sensor reports in. Do not touch any buttons until
synchronization is complete.
If the synchronization fails, reset the console by removing one battery from the display console,
disconnect from AC power, wait 10 seconds, and reinsert the battery and reconnect AC power..