User Manual

Version 2.0 Page 10
Medium
RF Signal Strength Reduction
Glass (untreated)
5-15%
Plastics
10-15%
Wood
10-40%
Brick
10-40%
Concrete
40-80%
Metal
90-100%
4 Console Operation
Note: The console has four keys for easy operation: TEMP/+ key, ALARM key, BARO/-
key and SET/CH/CH key. There are four program modes: Set Mode, Alarm Mode, Calibration
Mode and Min/Max Mode.
Any program mode can be exited at any time by either pressing the SNOOZE/LIGHT key (on
the top of the display console), or waiting for the 30-second time-out to take effect.
4.1 Set Mode
The Set Mode allows you to change date, time, units of measure and other important functions, as
referenced in Figure 8.
To enter the Set Mode, press and hold the SET/CH key for two seconds (SET/CH + 2 seconds).
To advance each command, press (do not hold) the SET/CH key.