User's Manual

Version 1.0 Page 7
3.6.2 Software Requirements
An IP scan tool is required to locate the ObserverIP on the network.
3.6.3 ObserverIP Connections
Connect the ObserverIP receiver power jack to AC power with the power adapter (included), as shown
in Figure 5, reference 10.
Connect the OberverIP receiver to your router using the Ethernet cable (included), as shown in Figure
5
, reference 8.
Place the indoor and outdoor transmitters about 5 to 10 feet from the ObserverIP receiver and wait
several minutes for the remote sensors to synchronize with the receiver. Once synchronized, the
Indoor blue LED (Figure 4, reference 2) and Outdoor blue LED (Figure 4, reference 3) will be
illuminated.
Ref. LED Description
1 RF On when radio frequency receiver is operating properly
2 Indoor On when indoor sensor received
3 Outdoor On when outdoor sensor received
4 Server On when connected to Wunderground.com® internet hosting
service
5 ACT Flashes when there is internet activity
6 Link Connected to the Internet (or router)
7 Power AC Power connected
Figure 4