User Manual

indoor sensor
Remove the battery door on the back of the sensor with a Philips screwdriver (there is only one screw, at the
bottom of the unit). Insert two AAA batteries as shown in Figure 10 (we recommend lithium batteries for cold
weather climates, but alkaline batteries are sufficient for most climates).
Replace the battery door and set screw. Note that the temperature, humidity and pressure will be displayed on
the LCD display. Looking at the back of the unit from left to right, the polarity is (-) (+) for the top battery and (+)
(-) for the bottom battery.
Figure 10
Initial Display Console Set Up
Connect the power adapter to power up the display console.
The display console starts to register the transmitter and receiver the weather data from transmitter. The
interface as below
:
Then it start to scan the Wi-Fi network, if it didn’t found the available Wi-Fi it will shows” not find any
AP (
Access Point)”
. Press key to return to normal display mode. Only after connect to WLAN
you can upload the data to weather website. If the data upload to server successfully, the icon
will show on beneath the wind chill.
- 7 -